Flite Test was started in a garage by a group of individuals passionate about flight and community. Your one-stop gateway to the most exciting hobby in the world!.
The FT Tiny Trainer is a Mighty Mini that is specifically designed to cover all the basics when it comes to RC Flight. Whether you are a beginner yourself, or if you are trying to bring a newcomer into this wonderful hobby, the Tiny Trainer will assist them in making every flight a great experience! This plane can be built and converted into 4 different designs that will guide you through every level of getting started flying.
TINY TRAINER ASSEMBLY GUIDE
Educators, group leaders, and parents looking to make a memory with a loved one can build the Tiny Trainer as a free flight (hand tossed) glider or a powered RC airplane. A little clay in the nose for balance, and your ready to toss the plane back in forth with a friend! Remove the clay and add 2 servos and you have a great 2 channel glider to learn elevator and rudder control. Swap out your glider nose for the powered nose and enter into the world of 3 channel flight. Once you are comfortable with slow lazy eights and graceful loops, remove the polyhedral wing and replace it with the included sport wing. The sport wing will teach you bank and yank skills and enter you into world of aerobatics and precision flight. Install a 3 cell battery and go from cruising to cutting up the sky with vertical lines and exhilarating speed.
The Tiny Trainer will also get you up to speed with techniques used with all FT designs. Every technique from "A Folds" to Folding wing airfoils will be used in this one build.
- Laser-cut foam airframe
- Power Pod (Mini)
- Firewall (Mini)
- Push rods
- Control horns
- BBQ Skewer
- Data Sheet
- Hook-and-Loop strap fastener
- 2 Rubber Bands
Note:This includes the airframe only (no electronics).
Required to Complete
- Transmitter & Receiver
- Motor: 2200 kv 250 size motor Recommended
- Prop: 6 x 3 prop minimum Recommended
- ESC: 12 amp minimum Recommended
- Battery: 500 - 800 mAH 2s or 3s lipo Recommended
- Servos: (2 - 4) 4.5g - 9g servos Recommended (HP-DS09-SCD X 2-4)
- Compatible LiPo Charger
Please see yutube video for building instruction:
- Weight (Without Battery): 6.8oz (193g)
- Center Of Gravity: 1.5 - 1.75 inches (38-44 mm) from leading edge of wing
- Control Surface Throws: 16 ̊ deflection (elevator/rudder) Expo 30%
- Wingspan: 37 inches (940 mm)
Note: Please watch recent build videos before removing any paper from the foam! Some videos may use white foam board, which is no longer available and has now been replaced with water-resistant foam board.
NOTE: This Item is too large for the Japan Parcel Post shipping option. You must select EMS EXPRESS or FedEx SHIPPING METHOD at checkout time.