• Two INPUT power choices:
  Use AC 100~240V at home
  DC 11~15V anywhere
   

• 2 Line LCD for charge monitor and post data display

• Charge/Discharge
  *1-14 cell NiCd/NiMH Batteries
  *2-12v Lead Acid Batteries
  *1-5 cell Lithium Ion or Lithium Polymer Batteries

• Li-Po PCM Guard and Balancer Safe

• DataPort Interface for EOS LBA 10 Balancers

• 0.1-5A Charge Current

• 0.1-1A Discharge Current

• Fast Auto Charge Algorithms for NiCd and NiMH

• 12.0~15.0V DC input voltage

• Audible Function Alarm

• Easy Lithium Programming

• Output Charge Cord/Connector set included ($4.00+ value)

• Double-length Input cord for convenience

It contains the same advanced features to support safer charging of Lithium batteries, including special circuitry to insure that PCM Guard devices are not damaged on open-circuit conditions.  Most chargers will output a high voltage when encountering PCM open circuit, thus damaging the PCM, but the EOS 5i DP AC/DC limits output to an always- safe maximum of 25V. 

The DataPort version EOS chargers, when connected to LBA10 balancer via cable #HP-EOSLBA10-DPC, allow the user to monitor the individual voltages of each battery cell during the charge process. The LBA communicates with the charger, giving notification when balance charging is completed, or when an error is detected and tells the charger to shut down. This insures maximum safety.

The EOS 5i DP, with its max charge rate of 5 ampere, is ready for large capacity lithium packs.  The discharge and cycling programs allow you to easily diagnose the condition of your packs, with a Data View mode that conveniently displays detailed information about the charge or discharge cycle.

• The EOS 5i is limited to Lithium-Polymer and Lithium ION batteries with nominal voltage of 3.7V per cell.  Selection for legacy Li-Ion batteries having 3.6V/cell is not available (3.6v Li-Ion cells are obsolete since 2003, in our opinion...).  This makes the Charger much easier to use, as an entire second-level menu is eliminated.  Having only one type of cell also allows the EOS 5i to display lithium 1S, 2S, 3S, 4S, 5S... rather than choosing a voltage.  So the EOS 5i interface is easier to use and safer because you can't choose the wrong per-cell voltage.
   
• Input cord (to car battery, etc) is twice as long, so you can rest the charger on the ground rather than trying to balance it on top of a hot car engine.
   
• Charger comes with red/black output charge cords: 20cm long, 12 ga silicone wire, two 4mm Male Banana Plugs attached one end, soldered wire other ends.  The customer only need solder on his preferred battery connector. (you can see the cords attached in the picture above)
   
• As noted above, the EOS 5i limits voltage on open circuit, so that it is guaranteed safe for any PCM or Balancer device.  This is unique to the Hyperion EOS Charger line.