Air Craft
DataSheet
Z22 Series
Brushless OutRunners
CLICK HERE FOR PRICING
|
|
Air Craft |
HYPERION Z22 Series Brushless OutRunners CLICK HERE FOR PRICING |
See General Guide for Brushless Motor/Controller installation here.
|
The new Z22 Series Hyperion Outrunners are some of the best-built motors we have ever seen. From front to back, only the highest quality materials and components are used. The arrangement of twelve stator poles and fourteen magnet poles is primarily responsible for the high torque the Z Series generates on direct drive. But there is much more to the "Z" than that. The stators are hand-wound in an optimal pattern for copper packing, so we get less resistance for a given number of turns. The stator plates are produced via a CNC process that insures uniformity, and made of a new silicon steel with superior permeability at high induction. The stator plates are finished with a lifetime anti-oxidant coating, to eliminate losses which can occur due to magnetic shorting from corrosion. |
|
The magnets are especially made for the Z Series motors,
and are rounded
|
|
| Side View Z2209 Back View Z22 Series Front View Z22 Series (see dimensions above, left) | |
   As
you can see, the shaft arrangement makes it easy to front or backmount the
motors, and use either a M5 x 3mm collet adapter or a prop-saver adapter on
either end.
The shafts, retained by setscrew, are easily replaceable in the event of a
crash, and are available for order. |
|
|
The "22" in Z22 stands for the 22mm diameter of the stator,
and the "05", "09" and "13" are the length of the stator in millimeters. |
|
|
Z2213 Motor with HP-Z22-BKMNT |
Z2205 Motor with Backmount plate |
  |
  |
See General Guide for Brushless Motor/Controller installation here.
on
both bell and stator sides. The result it that contact area with the bell is
complete, and this has two benefits: First, heat transfer is
maximized, so the magnets are much less subject to damage from overheating.
Second, the full contact with the bell on one side, and matching curvature
to the stator on the other, means that the magnetic flux lines are complete
and optimally shaped; this means higher efficiency, lower incidence of
motor stalling, and smoother starts. The magnets themselves are
produced in one of the foremost factories in t
he
world, and are the latest type, featuring both an extremely high temperature
rating and high magnetic strength. They are retained by fingers in the
bell-end, and attached with a special high-temp glue made for the Japanese
space program. We think it's just about impossible to throw a magnet,
or termperature de-mag these motors, and we've tried very hard... Finally, the
high-speed, shielded stainless bearings in the Z Series are made by NMB
Japan; expensive for Hyperion to install, but well worth it for
smoothness and longevity. As you'll see in the specifications and prop data,
the Z-Series have very high power-to-weight ratios. The Z2209-32 at
only 41.7g, for instance, is a tremendous performer on 3S li-po and 10x3.8
APC SF prop in E3D models weighing up to 350 grams.